Heater with manual controls

Heater with manual controls

DISTRIBUTOR HEATER ASSEMBLY

Removing

• Drain the engine cooling system;
• remove the upper tunnel and instrument facia trim (see pages 30 and onward in section 70);
• working in the lower rear part of the engine bay, loosen the two clips arrowed in the figure alongside and disconnect the two rubber pipes from the ends of the metal pipes protruding from the engine bay, which are connected to the heater radiator double fitting;
• unscrew the bolts indicated by the arrows in the lower figure, which secure the heater - distributor assembly to the body;
• disconnect electrical connection (1) and remove the above assembly from the vehicle;