Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)09 · 55 Electrical system
09 · Electrical

Removing-refitting control unit air bag system

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Air bag › Removing-refitting control unit air bag system
55 Electrical systemRemoving-refitting control unit air bag system

REMOVING-REFITTING CONTROL UNIT AIR BAG SYSTEM

Disconnect and insulate the battery terminals, then carefully observe the safety rules described from page 99 onward.

Diagram showing the location of bolts and fastening studs on the right hand trim panel beneath the instrument facia.
  1. Unscrew the bolt and undo the fastening studs. Then disconnect the trim panel located beneath the instrument facia (the right hand panel is shown in the figure. Repeat the procedure for the left hand panel).
Diagram showing the tunnel trim area with a connection being disconnected by turning a retaining lever in the arrowed direction.
  1. Remove the tunnel trim from the car as described on page 30 of Section 70 - Bodywork, then disconnect the connection by turning the retaining lever in the arrowed direction.
Diagram showing a hand using a tool to undo three hexagonal-headed socket screws securing the electronic control unit.
  1. Disconnect the electronic control unit by undoing the three 5 mm hexagonal-headed socket screws.

Tighten the control unit retaining bolts to a torque of 0.8 daNm.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.