Service control unit

Service control unit

1. Green led
2. Store button

Receiver connector

1. Not connected
2. Provision for alarm system
3. Positive from battery (+30)
4. Earth
5. Door release
6. Door lock
7. Ingiton-operated positive (+15)
8. Not connected

1. Red LED on remote control unit
2. Password code, 4-figure
3. Control button on sender unit
4. Green LED on courtesy light
5. Programming button

SIMPLIFIED PROGRAMMING

A remote control unit must always be stored with the ignition key remove or in STOP or PARK position

With this programming system, any number of remote control codes are recognised but only the last 8 remain stored by the alarm system as follows:

1. press and hold down button (5) on the receiver built into the courtesy lightl. The adjacent LED (4) should flash.
2. Hold button (5) down and press remote control unit key (3).
3. Then release key (3) when the light of led (4) on the receiver should become fixed.
4. Then release button (5) on the courtesy light at the end of the cycle.
5. The remote conrol unit is now programmed.

NOTE Repeat the operations below to store the next remote control units.

6. If the receiver led stops flashing and goes off (when the remote control ke is pressed), the receiver memory is closed. Use PROTECTED PROGRAMMING to store the remote control unit code.

PROTECTED PROGRAMMING

If the memory is closed, further remote control codes can be entered onlly after opening the memory.

OPENING MEMORY AND STORING A NEW REMOTE CONTROL UNIT

Opening the memory

To open the memory, carry out the following operations in rapid succession:

1. Press button (5) on the receiver for about 1 second. LED (4) flashes as long as the button is pressed.
2. Release the button; after about 3 seconds, the LED emits a short flash to indicate that the first figure of the password can be entered.