Airbag failure warning light on
- Make
- Fiat
- Model
- Doblò Factory Service Manual
- Year
- 2000–2010
- Section
- Air bags › Airbag failure warning light on
AIRBAG FAILURE WARNING LIGHT ON
During starting, the air bag failure warning light comes on and remains on for more than 4 seconds (after the control unit initial test, the warning light should go out)
In the case of a reasonably serious impact which has caused the activation of the complete system (Air Bag and Side Bag), the warning light stays on. The control unit memory cannot be cleared, so the control unit must always be replaced. If, on the other hand, only the pretensioners or the Side Bags have been activated, the memory can be cancelled using the diagnostic equipment (Examiner or other instruments) twice. In this case the 'Air Bag Failure' warning light goes out. The control unit only has to be replaced if it is activated a third time.
| Results of the tests | ||||
| 1 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|---|---|---|---|
| Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket | Check for faults in the control unit Continue to Step 10 | Driver Bag Error detected | Continue to Step 2 | |
| Driver Bag Error detected | Continue to Step 3 | |||
| Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket | Check for faults in the control unit Continue to Step 10 | Driver Bag Error detected | Continue to Step 2 | |
| Passenger Bag Error detected | Continue to Step 3 | |||
| Driver Side Bag Error detected | Continue to Step 4 | |||
| Passenger Side Bag Error detected | Continue to Step 5 | |||
| Driver's Side Sensor Error detected | Continue to Step 6 | |||
| Passenger Side Sensor Error detected | Continue to Step 7 | |||
| Driver Pretensioner Error detected | Continue to Step 8 | |||
| Passenger Pretensioner Error detected | Continue to Step 9 | |||
| 2 | DRIVER'S AIR BAG CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the explosive charges, disconnect the battery leads for 10 minutes Check under what circumstances the error disappears See Test 5580CA | Continue to Step 10 | The line closing resistance eliminates the error: bag faulty | Replace the bag Op. 5580C18 | |
| The line closing resistance eliminates the error: bag faulty | Replace the clock spring Op. 5580C12 | |||
| The line closing resistance eliminates the error: bag faulty | Restore connections See E7030 AIRBAG | |||
| The line closing resistance eliminates the error: bag faulty | Replace control unit Op. 5580C14 | |||
| 3 | PASSENGER BAG CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the explosive charges, disconnect the battery leads for 10 minutes Check under what circumstances the error disappears See Test 5580CB | Continue to Step 10 | The line closing resistance eliminates the error: bag faulty | Replace the bag Op. 5580C22 | |
| Connections not correct | Restore connections See E7030 AIRBAG | |||
| Control unit faulty | Replace control unit Op. 5580C14 | |||
| 4 | DRIVER'S SIDE BAG CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the explosive charges, disconnect the battery leads for 10 minutes (referring to the driver's Side Bag line) check under what circumstances the error disappears See Test 5580CB | Continue to Step 10 | The line closing resistance eliminates the error: side bag faulty | Replace the side bag | |
| Connections not correct | Restore connections See E7030 AIRBAG | |||
| Control unit faulty | Replace control unit Op. 5580C14 | |||
| 5 | PASSENGER SIDE BAG CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the explosive charges, disconnect the battery leads for 10 minutes (referring to the passenger Side Bag line) check under what circumstances the error disappears See Test 5580CB | Continue to Step 10 | The line closing resistance eliminates the error: side bag faulty | Replace the side bag | |
| The line closing resistance eliminates the error: side bag faulty | Restore connections See E7030 AIRBAG | |||
| The line closing resistance eliminates the error: side bag faulty | Replace control unit Op. 5580C14 | |||
| 6 | DRIVER'S SIDE SENSOR CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the explosive charges, disconnect the battery leads for 10 minutes referring to the driver's Side Bag line See Test 5580CC | Continue to Step 10 | Connections not correct | Restore connections See E7030 AIRBAG | |
| Sensor faulty | Replace the sensor | |||
| Control unit faulty | Replace control unit Op. 5580C14 | |||
| 7 | PASSENGER SIDE SENSOR CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the explosive charges, disconnect the battery leads for 10 minutes referring to the passenger Side Bag line See Test 5580CC | Continue to Step 10 | Connections not correct | Restore connections See E7030 AIRBAG | |
| Sensor faulty | Replace the sensor | |||
| Control unit faulty | Replace control unit Op. 5580C14 | |||
| 8 | DRIVER'S PRETENSIONER CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the pretensioners, disconnect the battery leads for 10 minutes referring to the driver's Side Bag line See Test 5580CE | Continue to Step 10 | The line closing resistance eliminates the error: pretensioner faulty | Replace the driver's pretensioner Op. 7065A10 | |
| Connections not correct | Restore connections See E7030 AIRBAG | |||
| Control unit faulty | Replace control unit Op. 7065A04 | |||
| 9 | PASSENGER PRETENSIONER CHECK | All OK | Problems met | Operation |
Before any R/R operation involving the pretensioners, disconnect the battery leads for 10 minutes referring to the passenger Side Bag line See Test 5580CE | Continue to Step 10 | The line closing resistance eliminates the error: pretensioner faulty | Replace the passenger pretensioner Op. 7065A10 | |
| Connections not correct | Restore connections See E7030 AIRBAG | |||
| Control unit faulty | Replace control unit Op. 7065A04 | |||
| 10 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | Fault persists | Search for the fault starting from another symptom' | ||
Parts & tools for this job For 2000 Fiat Doblò
- TOOLOBD2 scanner with SRSSearch: OBD2 scanner ABS SRS
- TOOLTrim removal tool kitSearch: trim removal tool kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.