22 · Diagnostics

Engine not running smoothly

Make: Fiat
Model: Doblò Factory Service Manual
Year: 2000–2010
Section: Engine › Engine not running smoothly

‹ Prev Engine not running smoothly / (irregular operation)Next › Engine does not produce best performance

Fault diagnosisEngine not running smoothly

ENGINE NOT RUNNING SMOOTHLY

There are decreases in performance during acceleration

0	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Check, in order: the condition of the air intake circuit that there are no faults in the air filter whether the diesel pipes are leaking the accelerator pedal travel that there is no water, petrol, paraffin or dirt in the fuel tank and filter	Continue to Step 1	Faulty in the air intake circuit	Restore the air intake circuit
			Air filter clogged	Replace the filter element
			Leak from diesel pipes	Stop the leaks
			Accelerator pedal travel incomplete	Eliminate the cause of the problem
			Presence of water, petrol, paraffin or dirt detected	Clean the tank and pipes and replace the filter element
1	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket. Verify: that there are no errors in the control unit parameter plausibility	Continue to Step 2	Error detected in the control unit	Continue following the instructions for the diagnostic equipment
		Continue to Step 2	Implausible parameters	Proceed as indicated on the tester
2	CHECK EGR AND ADJUST TURBOCHARGER	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket. Carry out active diagnosis of EGR solenoid valve	Continue to Step 3	EGR solenoid valve not working	Check the continuity of the wiring See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENTand if necessary replace the solenoid
		Continue to Step 3	Turbocharger solenoid valve not working	Check the continuity of the wiring See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT, if necessary, replae the solenoid valve
3	ROAD TEST WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Road test the vehicle, reproducing the conditions in which the fault arises, keeping the diagnostic equipment connected. Verify: that there are no errors in the control unit parameter plausibiilty	Continue to Step 4	Error detected in the control unit	Continue following the instructions for the diagnostic equipment
			Implausible parameters	Continue following the instructions for the diagnostic equipment
			Lack of dialogue with the control unit	Restore the connection between the engine management control unit and the diagnostic connector.
4	CHECK ON TURBOCHARGER	All OK	Problems met	Operation
	Check turbocharger operation as described See Test 1064BA Check turbo presure	Continue to Step 5	Turbocharger faulty	Replace the turbocharger Op. 1064B19
5	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists: control unit defective	Replace the engine management control unit Op. 1060G80

‹ Prev Engine not running smoothly / (irregular operation)Next › Engine does not produce best performance

Parts & tools for this job For 2000 Fiat Doblò

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.