Rear suspension end buffer - replace
- Make
- Fiat
- Model
- Doblò Factory Service Manual
- Year
- 2000–2010
- Section
- Rear suspension › Rear suspension end buffer - replace
‹ Prev Rear suspension axle -replace- includes r+r, check, parts transfer and bleedingNext › Front wheel geometry - check using optical equipment - includes front wheel tow-in adjustment if necessary
Suspension and wheelsRear suspension end buffer - replace
Rear suspension end buffer - replace
Removing
Place the car on a lift.
1. Unscrew the rear suspension end stop buffer.
Refitting
Tighten the buffer into its seat on the body.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | REAR END STOP BUFFER | M10 | 2.9 |
Remove the car from the lift.
‹ Prev Rear suspension axle -replace- includes r+r, check, parts transfer and bleedingNext › Front wheel geometry - check using optical equipment - includes front wheel tow-in adjustment if necessary
Parts & tools for this job For 2000 Fiat Doblò
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTRear shock absorbersSearch: Fiat Doblò 2000 rear shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.