05 · Steering & suspension

1. Tooling (page 3 of 3)

Make: Fiat
Model: Ducato Mk3 (250) Factory Service Manual
Year: 2006–2017
Section: Steering mechanism: removing - refitting

05 Steering - 3.0 HDi1. Tooling · page 3 of 3

Close-up of a low pressure pipe labeled 12 connected at point a, with surrounding hydraulic components visible.

Uncouple : The low pressure pipe (12) (at "a").
Plug the hydraulic unit unions; Using plugs .
Disconnect the power steering regulated electrovalve connector (if necessary).

Two views (A and B) showing bolts labeled 13 securing a steering column component at point b. View A is for left-hand drive, View B is for right-hand drive.

Fitting A : Left-hand drive .
Fitting B : Right-hand drive .
Remove bolts (13).
Disengage and push the lower part of the steering column upwards (at "b").

Undercarriage view showing bolt 15 in the center, two bolts labeled 14 on either side, a bracket labeled 16, and four bolts labeled 17 at the corners. Arrows indicate removal direction for bolts 14.

Remove the bolt (15).

‹ Prev Next › 3. Refitting

Parts & tools for this job For 2006 Fiat Ducato

TOOLTie rod end toolSearch: tie rod end puller
TOOLBall joint separatorSearch: ball joint separator
FLUIDPower steering fluidSearch: Fiat power steering fluid

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.