3. Refitting

• The supply pipe (7) of the master cylinder

Plug the clutch master cylinder supply pipe (7).
Remove the clutch control pipe retaining clip (9).
Uncouple the clutch control pipe (10).
Remove the pedal bracket.

3. Refitting

Position the pedal bracket .
Couple the clutch control pipe (10).
Refit the clutch control pipe retaining clip (9).
Couple up :

• The supply pipe (7) of the master cylinder
• The clip (8); Using tool [0172-Z]
• The retaining clip (6)

Reconnect the connectors.

Refit the strengthening tube (4).
Refit and tighten :

• The (5) bolt
• The nut (3)

Refit :

• The nuts (2); Tighten to 2,2 daN.m
• The nuts (1); Tighten to 2,2 daN.m
• The steering column
• The stop lamp connector
• The built-in systems interface (if necessary)
• The fascia lower cover

Bleed the hydraulic clutch control.

CAUTION : Perform the operations that are required following a reconnection of the ancillaries battery.

Reconnect the ancillaries battery.