Rear calliper bracket - r r
- Make
- Fiat
- Model
- Multipla Factory Service Manual
- Year
- 1998–2010
- Section
- Disc brakes › Rear calliper bracket - r r
Rear calliper bracket - r r
Removing
Place the car on the ramp.
Disconnect the battery negative terminal.
| Name | Connector | |
|---|---|---|
| Battery | A1 |
1. Working from inside the vehicle, remove the protective boot for the handbrake lever.
2. Loosen the adjustment nut for the handbrake cable.
- 4450B11 WHEEL (one) rear - R.R.
1. Release the handbrake cable and move aside.
2. Unscrew brake caliper retaining bolts (2a) and remove caliper (2b).
Release the rear brake pads.
1. Undo the rear brake caliper bracket retaining bolts.
Remove the caliper bracket.
Refitting
Fit the caliper bracket.
Tighten the bracket fixing bolts to torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | REAR BRAKE CALIPER BRACKET | M12 x 1 | 10.5 |
Fit the rear brake pads.
Refit the brake caliper and tighten the retaining bolts to torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | REAR BRAKE CALIPER | M10 | 5.7 |
Connect the handbrake cable to the brake caliper.
- 4450B11 WHEEL (one) rear - R.R.
Lower the vehicle.
- 3380A04 handbrake - check travel
Connect the battery negative terminal.
| Name | Connector | |
|---|---|---|
| Battery | A1 |
Remove the car from the ramps.
Parts & tools for this job For 1998 Fiat Multipla
- PARTRear brake padsSearch: Fiat Multipla 1998 rear brake pads
- TOOLCaliper piston rewind toolSearch: brake caliper piston rewind tool
- FLUIDBrake fluidSearch: brake fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.