Fuel filler pipe - r + r

Operation 1040A30 · FUEL TANK AND COMPONENTS

1.6 16v

Removing

Place the car on a ramp.

With the ignition key in the OFF position, disconnect the battery negative terminal.

- 4450B11 WHEEL (one) rear - R.R.

Raise the car.

1. Undo the retaining bolts.

2. Remove the plastic fuel filler pipe protection.

1. Unscrew the fuel filler fitting retaining bolts.

2. Lower the upper part of the filler pipe as far as possible and disconnect the pipe leading to the tank from the vapour separator.

3. Open collars (3a) and disconnect fuel filler pipe (3b) and pipe (3c) from the supplementary vapour separator to the tank.

4. Disconnect both pipes leading from the evaporation control system to the float valves from their quick-release fittings, then remove the filler pipe together with the vapour separator.

- 1080E10 tank fuel vapour separator - r + r

Refitting

- 1080E10 tank fuel vapour separator - r + r

Fit the fuel filler pipe together with the vapour separators.

Connect the tank pipe to the vapour separator.

Tighten the fuel filler fitting retaining bolts.

Connect both pipes from the evaporation control system to the float valves to their quick-release fittings.

Use new collars to secure the fuel filler pipe and the supplementary separator pipe from the tank.

Fit the plastic filler pipe protection.

- 4450B11 WHEEL (one) rear - R.R.

With the ignition key in OFF position, connect the battery negative terminal.

Remove the vehicle from the ramp.

1.9 JTD 8V

Removing

Place the car on a ramp.

With the ignition key in the OFF position, disconnect the battery negative terminal.

- 4450B11 WHEEL (one) rear - R.R.

Raise the car.

1. Undo the retaining bolts.

2. Remove the plastic fuel filler pipe protection.

1. Unscrew the fuel filler fitting retaining bolts.

2. Open collars (2a) and disconnect fuel filler pipe (2b) and pipe (2c) from the tank.

3. Remove the fuel filler pipe.

Refitting

Fit the fuel filler pipe.

Tighten the fuel filler fitting retaining bolts.

Use new collars to connect the pipes to the tank.

Fit the plastic filler pipe protection.

- 4450B11 WHEEL (one) rear - R.R.

With the ignition key in OFF position, connect the battery negative terminal.

Remove the vehicle from the ramp.