Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Multipla Factory Service Manual (1998-2010)22 · Fault diagnosis
22 · Diagnostics

Abs working irregularly

Make
Fiat
Model
Multipla Factory Service Manual
Year
1998–2010
Section
Braking system › Abs working irregularly
Fault diagnosisAbs working irregularly

ABS WORKING IRREGULARLY

When the brakes are operated vigorously and suddenly ("panic" braking), the ABS does not work properly, so one or more wheels lock(s).

Results of the tests
0PRELIMINARY CHECKSAll OKProblems metOperation
Turn the ignition on and check that the "ABS fault" warning light comes on for about 4 seconds, and then goes out.Continue to Step 1The "ABS fault" warning light comes on and stays onSee table K60 ABS FAILURE WARNING LIGHT ON
1CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket

Check:

  • that there are no faults in the ABS control unit
  • plausibility of all the parameters
Continue to Step 2An error is detected in the control unitContinue according to the instructions for the diagnostic equipment
Lack of dialogue with the control unitRestore the connection between the ABS control unit and the diagnostic connector ( See E7020 ABS)
Fault detected in a front sensorReplace the sensor Op. 3340A30
Fault detected in a rear sensorReplace the sensor Op. 3340A34
Fault detected in a front wheel hubReplace the wheel hub Op. 4450C10
Fault detected in a rear wheel hubReplace the wheel hub Op. 4450D10
2ACTIVE DIAGNOSIS WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

Using the diagnostic equipment (Examiner or other instruments) carry out the active diagnosis of:

  • pump motor
  • solenoids
Continue to Step 3Fault detected in one solenoidReplace electrohydraulic unit-electronic control unit Op. 3340A12
3CHECKING CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosisFault persistsSearch for the fault starting from another symptom'

Parts & tools for this job For 1998 Fiat Multipla

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.