Multipla Factory Service Manual (1998-2010): Suspension and wheels
General
Maintenance
Diagnostics
Engine
Transmission
Brakes
Steering & suspension
Heating & A/C
Electrical
Body & interior
Choose Sections to see everything in a chapter, or a chapter title to start at its first page.
- General › Introduction - SUSPENSION AND WHEELS
Front suspension10 pages
- Introduction - FRONT SUSPENSION
- Front suspension damper (one), lh or rh - for mcpherson strut system - includes dismantling/re-building of assembly at b
- Front suspension dampers - for mcpherson strut system - R+R - includes dismantling/re-building of assemblies at bench
- Lower wishbone (with balljoint) of left or right front suspension (one) - r+r -check wheel geometry separately
- Lower wishbone (complete with balljoint) of front suspension (one-remainder) - r+r following operation 4410b40
- Front suspension stabilizer bar - r+r - check wheel geometry separately
- Front suspension anti-roll bar end anchorage link (one), lh or rh - r r
- Front suspension beam - r r
- Front suspension crossbeam - r+r with wishbones removed
- Front suspension intermediate beam - r r
Rear suspension12 pages
- Introduction - REAR SUSPENSION
- L/h or r/h rear suspension damper (one) - r+r
- Rear suspension dampers - r r
- L/h or r/h rear suspension coil spring (one) - r+r
- Rear suspension coil springs- r r
- L/h and r/h rear suspension wishbones - r+r and strip
- Rear suspension wishbone (one remaining)- r+r following op.4420b30
- Rear suspension stabilizer bar - r+r
- Rear suspension axle - r+r includes bleeding
- Rear suspension axle -replace- includes r+r, check, parts transfer and bleeding
- Rear suspension end buffer - replace with spring disconnected
- Rear suspension end buffer - replace
Wheels and hubs18 pages
- Front wheel geometry - check using optical equipment - includes front wheel tow-in adjustment if necessary
- Rear wheel geometry - check using optical equipment
- Rear wheel alignment - check using optical equipment
- Front WHEEL (one) - R.R.
- WHEEL (one) rear - R.R.
- Front or rear wheels (two) - r+r
- Rear wheels(2) r r
- Wheels (four) - r+r
- Front pillar (one), l/h or r/h complete with wheel hub - r+r with wheel removed - check wheel geometry separately
- Front pillars (two) complete with wheel hub - r+r with wheels removed - check wheel geometry separately
- One front wheel hub bearing, lh or rh - replace
- One front wheel hub bearing - lh or rh - replace following operation 4450c32
- Bearing of one front wheel hub, l/h or r/h - replace with pillar removed
- One front wheel hub bearing, remaining, lh or rh - replace with pillar removed
- Hub cap of one front wheel, l/h or r/h - r+r
- Hub of one rear wheel, l/h or r/h - r+r with wheel removed
- Hub of one rear wheel(remaining), lh or rh r r with wheel removed
- Hub cap of one rear wheel, l/h or r/h - r+r