Bonnet lid - square

Operation 7025A10 · Bonnet lid

Lift up the bonnet lid.

If necessary, adjust the position of the lock as described in the procedure:

Refer to op. 7025A34 bonnet lid lock (one) - r+r or repair

1. If necessary, adjust the position of the buffers.

2. If necessary, loosen the bolts fixing the hinges and adjust the position of the bonnet lid.

The arrows indicate possible movements.

Tighten the hinge bolts.

If the adjustments described above are insufficient, adjust bonnet lid hinge position as described below.

Refer to op. 5050B34 windscreen wiper arm/s complete with blade - r+r (Both)

Refer to op. 7210E22 R.R. WINDSCREEN BASE TRIM

Loosen the bolts fixing the bonnet lid hinges to the bodyshell.

Adjust the position of the bonnet lid hinges moving them in the four possible directions until the bonnet lid is aligned.

Tighten the bolts fixing the bonnet lid hinges to the bodyshell to the recommended torque.