Pressure pump/manifold pipe - r r

Operation 1060F20 · Injectors and lines

1.3 JTD 16v

Removing

Disconnect the battery negative terminal.

1. Disconnect the electrical connection from the air flow meter.

2. Loosen the band and disconnect the air inlet hose to the turbocharger.

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

1. Undo the connectors (1a) and remove the pipe from the pressure pump to the fuel manifold (1b).

When refitting, fit a new pipe from the pressure pump to the fuel manifold.

Refitting

1. Fit a new pipe from the pressure pump to the fuel manifold in place and fix it using the connectors without tightening them.

2. Tighten the connector for the pipe from the pressure pump to the single fuel manifold, pump side, to the recommended torque using a suitable spanner.

3. Tighten the connector for the pipe from the pressure pump to the single fuel manifold, fuel manifold side, to the recommended torque using a suitable spanner.

Fit the air filter complete with air flow meter in place.

Connect the air inlet hose to the turbocharger and tighten the band.

Connect the electrical connection to the air flow meter.

Connect the battery negative terminal.