Water pump - r + r with engine removed
- Make
- Fiat
- Model
- Panda Factory Service Manual
- Year
- 2003–2012
- Section
- Engine cooling › Water pump - r + r with engine removed
EngineWater pump - r + r with engine removed
Water pump - r + r with engine removed
Removing
1. Use a spanner on the moving tensioner (1a) and remove the engine components single drive belt (1b).
2. Undo the nuts (2a) and remove the water pump (2b) complete with gasket.
Refitting
1. Place the water pump (1a), complete with gasket, back in its housing and secure it tightening the bolts (1b) to the recommended torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| 1b | Nut | COOLANT PUMP | M6 | (Upper engine crankcase side) 0.8 ÷ 1.0 |
2. Use a spanner on the moving tensioner (2a) and fit the single drive belt (2b).
Parts & tools for this job For 2003 Fiat Panda
- PARTEngine gasket setSearch: Fiat Panda 2003 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.