Rear suspension

Make

Fiat

Model

Punto (176) Factory Service Manual

Year

1993–1999

Section

Suspension (1108 SPI, Eastern Europe) › Rear suspension

00 Introduction and technical dataRear suspension · page 1 of 2

Rear suspension

Rear suspension independent, with coil springs.

Cast iron arms with bearings.
Stabilizer bar,rubber buffers

COIL SPRINGS

Part number	46400818
Diameter of wire	mm 12,5±0,1
Number of turns	4,75
Direction of coil	clockwise
Height of spring released	mm 272,7
Height of spring under a load of:	336 ± 10 daN mm 185
The springs are subdivided into two categories, identifiable by a mark
yellow (1) for those under a load of:	336±10 daN height of mm >185
green (1) for those under a load of:	336±10 daN height of mm ≤185

(1) Springs of the same category must be fitted.

SHOCK ABSORBERS

Type: telescopic, double acting (low pressure gas)	BOGE or WAY-ASSAUTO
Part number	BOGE	7789197
	WAY-ASSAUTO	7736585
Open (start of damping action)	BOGE mm	293 ± 2
	WAY-ASSAUTO mm
Closed (metal against metal)	BOGE mm	209 ± 2
	WAY-ASSAUTO mm
Travel	BOGE mm	84
	WAY-ASSAUTO mm

01 General