Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Punto (176) Factory Service Manual (1993-1999)04 · 21 Gearbox and differential
04 · Transmission

Fault diagnosis

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Automatic transmission (Selecta, '96 update) › Fault diagnosis
21 Gearbox and differentialFault diagnosis

FAULT DIAGNOSIS

Fault detected Causes and corrective actions
Parking device does not operate with vehicle on a gradient 1) Check transmission lever position corresponds to switch
2) Replace the transmission if the fault persists
Oil leaks 1) Main points to check and adjust if necessary:
- Oil sump
- Oil drain plug
- Kick-down cable sealing ring
- Heat exchanger and lines
- Right and left hand outlet fitting
- Secondary pressure outlet sealing ring
- Transmission intake fitting
2) Change transmission if fluid leaks occur from other points or cannot be mended
Vehicle will start with the selector lever in any position 1) Check multifunction switch adjustment
2) Check electrical connections
3) Check transmission cable adjustment
Vehicle moves forward or backward during start-up with lever on "N" or "P"" 1) Check and adjust transmission control cable
2) Change the transmission if the defect persists
Engine cannot be started with the selector lever on "P" or "N"" 1) Check transmission cable adjustment
2) Check electrical connections
3) Check multifunction switch
Gear selection system does not work properly 1) Check and adjust the gear cable
2) Check condition of electromagnetic clutch supply brushes and connections
3) Check setting of both microswitches on the accelerator pedal
4) Replace the transmission and clutch if the defect persists
No pulling power in "D", "L" or "R" with the accelerator pedal depressed 1) Check fluid level in transmission
2) Check and adjust the gear selector lever
3) Check clutch closure using a Fiat-Lancia Tester
4) Check transmission position with multifunction switch
5) Check setting of both microswitches on the accelerator pedal
7) Check transmission fluid pressure
8) Replace the electronic control unit if the defect persists
9) Replace the transmission and clutch if the defect persists
6) Check condition of electromagnetic clutch supply brushes and connections

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.