<x>TAILGATE REARSCREEN GLASS. - R.& R.</x>

Operation 7035B21 · REAR WINDOW

Removing

See in Op. 5530B56 BATTERY DRIP TRAY COVER

- Disconnect the negative battery terminal.

See in Op. 5550D16 third brake light - r r

See in Op. 7015A04 TAILGATE INNER PANEL - R and R

See in Op. 5050C34 REAR WINDSCREEN WIPER ARM COMPLETE WITH BLADE - R.R.

See in Op. 7015A58 Tailgate INTERNAL MOULDING (one) left or right - R and R

1. Disconnect the rearscreen washer pipe.

See in Op. 5050C42 rear wiper motor - r+r

1. Disconnect the two heated rear windscreen electrical connections.

1. Apply adhesive tape to protect the paintwork near the tailgate rear windscrfeen.

1. Working from the inside of the tailgate, pass the wire through the screen sealant and bring it out through the outside of the tailgate.

2. Fit the special tool.

1. Remove the rearscreen from the tailgate using the special tool.

a second mechanic is needed in order to carry out this operation.

Refitting

See in Op. 7035B26 REARSCREEN Clean edges and sand small abrasions

- Remove the seal using a jet through the opening in the glass.

- Apply the preparation for the sealant to the serigraphed area of the rearscreen.

Make sure after having applied the preparation for the sealant to wait for at least ten minutes before applying the sealant to the serigraphed area of the glass.

See in Op. 5050C42 rear wiper motor - r+r

- Fit the suction pads on the glass.

- Fit the seal using a jet through the opening in the glass.

1. Apply sealant to the serigraphed area of the rearscreen.

- Fit the rearscreen in the tailgate using the suction pads.

1. Place the windscreen in the housing, with the assistance of a second mechanic, straight after applying the sealant and let it bed in.

2. Position the belt (2a), as illustrated, and tension it so that even pressure is exerted on the entire windscreen to ensure that the matching between the glass (2b), sealant (2c) and windscreen housing (2d) is correct.

- Connect the rearscreen washer pipe.

- Connect the two heated rear windscreen electrical connections.

See in Op. 5050C42 rear wiper motor - r+r

See in Op. 7015A58 Tailgate INTERNAL MOULDING (one) left or right - R and R

See in Op. 5050C34 REAR WINDSCREEN WIPER ARM COMPLETE WITH BLADE - R.R.

See in Op. 7015A04 TAILGATE INNER PANEL - R and R

See in Op. 5550D16 third brake light - r r

- Connect the negative battery terminal.

See in Op. 5530B56 BATTERY DRIP TRAY COVER