Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Spindle: Service and Repair
Axle Shaft Service
Axle Shaft Service
REMOVE
1. Wheel and Tire assembly
2. Remove the Caliper assembly and Brake Rotor. Refer to Disc Brake System.
3. Remove the nuts retaining the spindle to the knuckle. Lightly tap the spindle with a rawhide hammer to remove it from the knuckle.
4. If required, remove the caged needle bearing from the spindle. Remove the seal. Pull the bearing out of the spindle using Collet (1-1/2 to 1-3/4
inch), D80L-100-T, Actuator Pin, D80L-100-H and Bridge Assembly, D80L-100-W or equivalents.
