Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Axle Shaft Service
Axle Shaft Service
INSTALL
1. If removed, position a new caged needle bearing in the spindle bore. The writing on the bearing must face the rear of the spindle, toward the
driving tool. Drive the bearing in the spindle with Spindle Bearing Replacer, T80T-4000-R and Driver Handle, T80T-4000-W or their equivalents.
Pack the bearing with High Temperature (4x4) Front Axle and Wheel Bearing Grease, E8TZ- 19590-A (ESA-M1C198-A) or equivalent. Install
the seal in the bore against the bearing.
2. Pack the thrust face of seal in the spindle bore and the V-seal on the axle shaft with High Temperature (4x4) Front Axle and Wheel Bearing
Grease E8TZ-19590-A (ESA-M1C198-A) or equivalent.
3. Place the spindle on the steering knuckle. Install the nuts and tighten to 68-81 Nm (50-60 ft lb).
4. Install the hub and rotor assembly on the spindle, inspecting the wheel bearings, and ensuring adequate lubrication with High Temperature (4x4)
Front Axle and Wheel Bearing Grease, E8TA-19590-A (ESA-M10198-A) or equivalent.
5. Install the inner locknut on the spindle and seat the bearing by tightening the locknut to 68 Nm (50 ft lb) with Spanner Locknut Wrench, D85T-1
197-A or equivalent.
6. Back off the inner locknut and retighten to 41-54 Nm (31-39 ft lb) while rotating the hub and rotor.
7. Back off the locknut 90 degrees.
8. Install the lockwasher so the key is positioned in the spindle groove. Tighten the inner locknut so the pin is aligned into the nearest hole in the
lockwasher.
9. Install the outer locknut and tighten to 217-278 Nm (160-205 ft lb) using Spanner locknut Wrench, D85T-1 197-A.
NOTE: The final wheel bearing end play should be 0.00-0. 15mm (0.000-0.004 inch). The maximum allowable torque to rotate the hub is 2.3 Nm
(20 in lb).
10. Install the locking hub body assembly in the hub and rotor.
12. Install the lock ring in the hub groove to retain the hublock body in the hub.
13. Install the snap ring on the end of the axle shaft to retain the shaft to the body.
14. Position the cap assembly with new seal on the body. Install the six allen-head capscrews and tighten to 4.0-6.0 Nm (35-45 in lb).
