Removal and Installation | -
Disconnect the battery ground cable. For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Raise and support the vehicle. For additional information, refer to: Lifting (100-02 Jacking and Lifting, Description and Operation). | | -
Remove the engine undershield. - Rotate the locking tangs counterclockwise.
| | -
Remove the starter motor solenoid electrical connector retaining nuts and detach the electrical connector from the starter motor solenoid (wiring harness shown removed for clarity). | 5. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Starter motor retaining bolts 6. To install, reverse the removal procedure. | -
Initialize the door window motors. For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | Installation Details Item 2 : Starter motor wiring harness ground connection NOTE:Make sure the starter motor wiring harness ground connection is in position before installing the starter motor retaining bolts. |