ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Headlamp Masking - Vehicles With: Adaptive Front Lighting > < Headlamp Masking - Vehicles Built Up To: 03-2007

C-MAX 2003.75 (06.2003-)

Exterior Lighting - Headlamp Masking—Vehicles Built From: 03/2007 C-MAX 2003.75 (06/2003-)
General Procedures

  1. Print out the corresponding templates at the end of this operation.
  1. Measure dimension X on the printout of the template.
  1. Calculate the enlargement/reduction factor Y for the photocopier using the following formula: Y=Z÷X×100.
  1.  
    • X = measurement on the printout of the template in mm
    • Y = enlargement/reduction factor in %
    • Z = original dimension in mm = 100
  1. Enlarge/reduce the printout with a photocopier by the calculated percentage.
  1. Compare dimension X on the photocopy with the original dimension.
  1. Cut out the prepared template for the headlamp.
  1. Align the templates in the shown way on upper and lower cover lens edges until both boundaries are matching.

Left-hand drive vehicles
  1. Left Headlamp

  1. Right Headlamp
Right-hand drive vehicles
  1. Left Headlamp

  1. Right Headlamp
All vehicles
  1. CAUTION:
    CAUTION:Take extra care not to scratch the headlamp lens.
    Copy the outlines of the templates with a suitable pen onto the headlamp lenses.
  1. Remove the templates.
  1. Mask the marked areas with opaque black adhesive tape.

  1. Template L/R

  1. Template R/L

Headlamp Masking - Vehicles With: Adaptive Front Lighting > < Headlamp Masking - Vehicles Built Up To: 03-2007