Crown Victoria V8-4.6L SOHC VIN 6 (1996)
41. Remove 14 bolts retaining camshaft cap cluster assemblies to cylinder head.
42. Tap upward on camshaft cap at position shown and gradually lift camshaft cap cluster from cylinder head.
43. Remove camshaft straight upward to avoid bearing damage.
NOTE: Steps 38 through 43 will remove only one camshaft. If both camshafts are being serviced, repeat Steps 38 through 43 to remove the other
camshaft.
Installation
1. Clean and inspect camshaft cover, front cover and cylinder head sealing surfaces.
2. Position camshaft on cylinder head. Apply oil to journals and lobes of camshaft.
3. Install and seat camshaft cap cluster assemblies. Hand-start 14 bolts.
NOTE: Each camshaft cap cluster assembly is tightened individually.
