Crown Victoria V8-4.6L SOHC VIN 6 (1996)
YES
REPLACE lamp.
NO
SERVICE open in circuit 705 (LG/O). RESTORE vehicle. RETEST system.
Illuminated Entry
Data Link Diagnostics
NOTE: The ignition switch must be in RUN position or test will fail. This test is used to verify the proper operation of communication circuit of each
module on the multiplex communication network or diagnostic communication network or diagnostic communication network.
1. Perform New Generation Star Tester Hookup and Vehicle Selection as outlined.
2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. If results of Circuit 914 (+) = 0000 and Circuit 915 (-) = 0000, then the Multiplex Communication Network link test passed. If non-zeros returned,
then go to Network Diagnostic Trouble Code (DTQ) Index.
4. If results of Circuit 70 (LBIW) = 0, then the Diagnostic Communication Network Link Test passed. If non-zeros returned, then go to Network
Diagnostic Trouble Code (DTC) Index.
On-Demand Self-Test
NOTE: This test is used to verify operation of module being tested.
1. Perform New Generation Star Tester Hookup and Vehicle Selection as outlined.
NOTE: The ignition switch must be in RUN position or test will fail.
2. Rotate dial to menu item Diagnostic Data Link and press trigger.
3. Select module to test by rotating dial to highlight module and press trigger.
4. Menu item Diagnostic Test Modes is highlighted. Press trigger.
5. Rotate dial to highlight menu item On-Demand Self Test. Press trigger, then press start (Button 3).
6. Prepare the vehicle for entry condition as specified for each module - press trigger.
Retrieve/Clear Continuous DTCs
1. Perform New Generation Star Tester Hookup and Vehicle Selection as outlined.
NOTE: The ignition switch must be in RUN position or test will fail.
2. Rotate dial to menu item Diagnostic Data Link and press trigger.
3. Select module to test by rotating dial to highlight module and press trigger.
4. Menu item Diagnostic Test Modes is highlighted. Press trigger.
5. Rotate dial to menu item Retrieve/Clear ConUnuous DTC, press trigger, then press start (Button 3).
6. Clear individual DTC from selected module, highlight DTC by rotating dial then press Button 8.
7. Clear all DTCs from selected module, press Button 7.
Retrieve PID Information
NOTE: This test is used to verify operation of input circuitry to the module being tested. The ignition switch must be in RUN position or test will fail.
1. Perform New Generation Star Tester hookup and vehicle selection as outlined.
2. Rotate dial to menu item Diagnostic Data Link and press trigger.
3. Select module by rotating dial to highlight module and press trigger.