Crown Victoria V8-4.6L SOHC VIN 6 (1996)
7. Remove window regulator electric drive retaining screws using a Torx® Drive Bit and separate window regulator electric drive from front door
power window regulator minus motor.
8. Remove window regulator electric drive from inside front door.
Installation
1. Position window regulator electric drive to front door power window regulator minus motor. Install three window regulator electric drive screws.
Tighten to 6 N.m (53 lb-in).
2. Position window regulator electric drive on inner panel and install three rivets.
3. Connect window regulator electric drive wiring.
4. Connect battery ground cable.
5. Remove tape from window glass and front door.
6. Check front door window glass operation. Install front door trim shield and front door trim panel. See: Body and Frame/Doors, Hood and
Trunk/Doors