Crown Victoria V8-4.6L SOHC VIN W (2005)
9. Remove the floor/defrost door vacuum control motor.
1
Remove the clip.
2
Remove the nuts.
3
Remove the floor/defrost door vacuum control motor.
10. Disconnect the vacuum lines.
11. To install, reverse the removal procedure.
Panel Door
VACUUM CONTROL MOTOR - PANEL DOOR
REMOVAL AND INSTALLATION
1. Remove the instrument panel. Refer to: Body and Frame, Interior Moulding/Trim, Dashboard/Instrument Panel, Service and Repair, Removal and
Installation, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Installation
2. Reach through the door opening and remove the pin.
3. Disconnect the panel door vacuum control motor vacuum line.