E 350 V8-6.0L DSL Turbo (2007)
Intake Manifold: Service and Repair
Installation
Intake Manifold
Installation
All vehicles
1. NOTE: The locating tabs on the gaskets must be positioned upward and toward the center of the engine, or a leak will occur.
Install the intake manifold gaskets and front module O-ring seal.
2. Install the intake manifold and bolts and tighten in 3 stages, in the sequence shown.
^
Stage 1: Loosely install bolts 1-8.
^
Stage 2: Tighten bolts 9-16 to 11 Nm (8 ft. lbs).
^
Stage 3: Tighten all bolts to 11 Nm (8 ft. lbs).
3. Slide the EGR cooler hose forward and rotate the flat to lock.