E 450 V8-5.4L (2009)
12. Remove the engine support insulator-to-cylinder block bolts, or bolts and nut, and remove the LH engine support insulator.
Installation
All engine support insulators
1. NOTE: Clean the engine support insulator-to-cylinder block mating surface of any dirt or foreign material prior to installation.
Position the engine support insulator being serviced and install the engine support insulator-to-cylinder block bolts, or bolts and nut.
-
For 5.4L engine, Install the 3 engine support insulator-to-cylinder block bolts.
-
For 4.6L engine, Install the 2 engine support insulator-to-cylinder block bolts and nut.
-
Tighten to 80 Nm (59 lb-ft).
RH engine support insulator
2. Position the RH engine support insulator bracket and install the 2 nuts.
-
Tighten to 90 Nm (66 lb-ft).
3. Install the engine support insulator bracket-to-crossmember nut.
-
Tighten to 90 Nm (66 lb-ft).
4. Using a suitable jack positioned on the RH rear of the cylinder block, lower the engine.
LH engine support insulator
5. Position the LH engine support insulator bracket and install the 3 nuts.
-
Tighten to 90 Nm (66 lb-ft).