E 450 V8-5.4L (2009)
-
Tighten to 25 Nm (18 lb-ft).
12. Remove the retaining clip from the LH timing chain tensioner.
13. NOTE: The lower half of the timing chain must be positioned above the tensioner arm dowel.
Position the lower end of the RH (outer) timing chain on the crankshaft sprocket, aligning the timing mark on the sprocket with the single copper
(marked) link on the timing chain.
14. NOTE: If necessary, use the Camshaft Alignment Set to adjust the camshaft sprocket slightly to obtain timing mark alignment.
Position the RH timing chain on the camshaft sprocket. Make sure the camshaft sprocket timing mark is positioned between the 2 copper (marked)
chain links.
15. Position the RH timing chain tensioner arm on the dowel pin and install the RH timing chain tensioner and the 2 bolts.
-
Tighten to 25 Nm (18 lb-ft).
16. Remove the retaining clip from the RH timing chain tensioner.
