ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Comprehensive Noise/Vibration/Harshness Procedure|Page 5006 > < Comprehensive Noise/Vibration/Harshness Procedure|Page 5004
Page 5
background image

6.

Verify the vehicle no longer dogtracks by rerunning the Diagnostic Procedure.

SUPERSEDES: 00-5-10

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION

DESCRIPTION

TIME

021608A

Correct Thrust Angle Or

1.6 Hrs.

Rear Axle

DEALER CODING

CONDITION

BASIC PART NO.

CODE

4210

42

OASIS CODES: 303000 304000, 305000, 390000

Technical Service Bulletin # 02-16-8

Date: 020819

Steering/Suspension - Apparent 'Dogtracking'

Article No.
02-16-8

08/19/02

SUSPENSION - VEHICLE APPEARS TO DOGTRACK - SERVICE TIP

FORD:
1992-2003 E SERIES

Article 00-5-10 is being republished in its entirety to update the vehicle model years.

ISSUE

The customer may report that an E-Series appears to dogtrack. This customer concern is generally due to unique features of an E-Series that combine to
create an optical illusion of dogtracking. Dogtracking is the condition in which the rear axle is not square to the chassis. Heavily crowned roads can add
to the illusion of dogtracking.

ACTION

Become aware of the unique features that can create the optical illusion of a dogtrack condition. Follow the Service Procedure to determine if a dogtrack
condition exists. If a dogtrack condition can be verified, follow the Diagnostic Procedure and Repair Instructions to correct the condition.

SERVICE PROCEDURE

NOTE

DOGTRACK CONDITIONS THAT ARE THE RESULT OF A COLLISION ARE NOT TO BE ADDRESSED USING THIS TSB.
DOGTRACKING THAT IS THE RESULT OF A COLLISION MUST BE REPAIRED USING GENERALLY ACCEPTED COLLISION REPAIR
TECHNIQUES.

NOTE

NEARLY ALL CUSTOMER REPORTS OF DOGTRACKING ARE THE RESULT OF THE OPTICAL ILLUSION DOGTRACKING THAT IS
COMMON ON THE E-Series.

Two unique conditions combine on the E-Series that enhance the optical illusion of dogtracking.

Comprehensive Noise/Vibration/Harshness Procedure|Page 5006 > < Comprehensive Noise/Vibration/Harshness Procedure|Page 5004