Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
11. Reconnect the RABS sensor, and the RABS harness to the retainers.
12. Properly route the left side rear parking brake cable for installation, and connect the cable to the support spring at the frame.
13. Install the right side (upper) and left side (lower) rear parking brake cables into the parking brake cable support bracket.
14. Connect the right side (upper) and the left side (lower) cable anchors to the parking brake cable equalizer and position into the retaining slots.
Tighten the parking brake cable equalizer adjusting nut until the previously recorded measurement is obtained.
15. Install the driveshaft.
16. Remove the supports and lower the vehicle.
17. Reconnect the battery ground cable(s).
