Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
10. Install the Differential Housing Spreader and the Dial Indicator/Magnetic Base on the axle housing.
-
Do not spread the rear axle housing more than 0.38 mm (0.015 inch).
11. Remove the differential case.
-
After the differential case is removed, remove the Differential Housing Spreader.
NOTE: Large pry bars will be needed to pry the differential case from the rear axle differential carrier. Use caution to avoid damage to the
ring gear.
12. Remove the differential bearing cups and the differential bearing shims.
-
The axle has selective shims installed outboard of each differential bearing cup. Remove both shims, indicating the side it was removed.
-
Inspect the shims for nicks, bending or grooved conditions. Replace as necessary.
-
Inspect the differential bearing cups for deep scores, galling or spalling. Replace as necessary.
NOTE: Mark or tag the differential bearing cups, indicating from which side they were removed.
