Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
6. Using a soft-faced hammer, drive the pinion assembly out of the front bearing cone and remove it through the rear of the housing.
-
Remove the rear axle drive pinion seal.
-
Remove the rear axle drive pinion shaft oil slinger.
7. Use the Bearing Pulling Attachment to remove the pinion bearing.
NOTE: Remove the collapsible spacer and discard it.
8. If the pinion bearing cups are to be replaced, tap alternately (with a brass drift of suitable length) on opposite sides of the cup during removal to
the prevent the cup from cocking in the casting.
NOTE: Do not remove the pinion bearing cups from the carrier casting unless the cups are damaged.
INSTALLATION