Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
5. Remove the driveshaft slip yoke.
1. Position the driveshaft slip yoke in the U-Joint Tool.
2. Press out a bearing cup.
3. Rotate the driveshaft slip yoke.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the driveshaft slip yoke.
NOTE: If necessary, use a pair of pliers to remove a bearing cup if it cannot be pressed out all the way.
6. Repeat Step 5 to remove the remaining bearing cups and spider from the driveshaft.
7. Clean the yoke area at each end of the driveshaft.
ASSEMBLY
1. Install the bearing cup.
1. Start a new bearing cup into the driveshaft yoke.
2. Position the new spider in the driveshaft yoke.
3. Using the U-Joint Tool, press the bearing cup below the yoke surface.
