Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
2. Remove the driveshaft from the U-Joint Tool, and install the snap ring.
NOTE: Use the yellow snap rings supplied in the kit to assemble the rear axle shaft universal joint (U-joint). If difficulty is encountered with the
yellow snap rings, install the black snap rings.
3. Repeat Steps 1 and 2 to install the remaining new bearing cups, spider, and driveshaft yoke.
4. Check the U-joints for freedom of movement.
-
If binding, strike the yoke with a brass or plastic hammer.
NOTE: Do not strike the bearings.
5. Install the driveshaft.