Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
14. Inspect the bearing rollers for pitting, galling or erratic wear patterns. Inspect the rollers for end wear.
1. A typical new bearing roller.
2. A worn bearing roller.
15. Remove the inner and outer bearing cups.
-
For E-Super Duty vehicles, remove the bearing cups using the Inner Bearing Cup Remover, Outer Bearing Cup Remover and Driver Handle.
-
For E-350 vehicles, remove the bearing cups using a brass drift.
16. Inspect the cups for pitting, galling or excessive wear.
If either the cup or bearing is worn or damaged, replace both components.
17. Inspect the rear hub. Replace the rear hub if any of the following conditions exist:
-
cracked material around bolt holes
-
depth of holes 40 mm (1.57 inches)
-
threaded for 25 mm (1 inch)
-
oversized holes
ASSEMBLY
