Escape 4WD V6-3.0L (2008)
11. Remove the intermediate and overdrive accumulator valve plug.
12. Remove and discard the intermediate and overdrive accumulator plug seal.
13. CAUTION: Remove, note location and clean one valve at a time to avoid incorrect installation.
As necessary, disassemble the parts of the accumulator body and main control valve body assemblies.
^
Lubricate and reassemble the parts as soon as possible to avoid accidental damage or incorrect installation.
Assembly
1. WARNING: When using compressed air, never let air pressure exceed 172 kPa (25 psi) and always wear safety glasses. Compressed air
may cause foreign material or parts to become airborne. Failure to follow this instruction may result in serious personal injury.
CAUTION: If the valve sticks in its bore and cannot be freed, install a new main control valve body.
NOTE: Clean the main control valve body and accumulator body assembly of the main control in cleaning solvent. Blow dry with moisture-free
regulated compressed air. The solenoid valve body should not be cleaned in cleaning solvent. It may be blown clean with compressed air or wiped
clean with a lint-free cloth.
Install a new intermediate and overdrive accumulator plug seal and coat with petroleum jelly.
