Expedition 2WD V8-5.4L (2009)
Radiator: Service and Repair
Radiator
Radiator
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the RH and LH headlamp assemblies.
3. Remove the cooling fan shroud. For additional information, refer to Cooling Fan Shroud See: Fan Shroud/Service and Repair.
4. Remove the 2 radiator bolts.
-
To install, tighten to 15 Nm (133 lb-in).
5. Remove the 2 bolts and position the coolant expansion tank aside.
-
To install, tighten to 15 Nm (133 lb-in).
6. Disconnect the electrical connector and remove the bolt and the horn assembly.
-
To install, tighten to 10 Nm (89 lb-in).