Explorer 4WD V8-302 5.0L VIN P SFI (2000)
12. Remove the differential case from the rear axle housing and remove the differential bearings using the special tools.
13. Use the special tool to install the new differential bearings on the differential case.
14. Install the differential case. Position the differential case assembly, including the bearing cups and shims in the rear axle housing. Tighten bearing
caps to specifications.
15. Measure the differential case runout without the ring gear, and check the case runout again with the new differential bearings.
-
If the runout is now less than the specification shown, use the new differential bearings for assembly.
-
If the runout is still excessive, the differential case is damaged and a new differential case must be installed.
