ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3204 > < Initial Inspection and Diagnostic Overview|Page 3202
Page 87
background image

GO to W25.

No

CONNECT the negative battery cable. GO to W62.

-------------------------------------------------
W27 VERIFY VEHICLE EQUIPMENT - ILCM

 

-

Inspect the vehicle for an Interior Lighting Control Module (ILCM).

-

Is the vehicle equipped with an ILCM?

Yes

GO to W28.

No

GO to W29.

-------------------------------------------------
W28 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE ILCM DISCONNECTED

 

-

Disconnect: ILCM C3498.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to W29.

No

CONNECT the negative battery cable. GO to W63.

-------------------------------------------------
W29 VERIFY VEHICLE EQUIPMENT - APIM

 

-

Inspect the vehicle for an Accessory Protocol Interface Module (APIM).

-

Is the vehicle equipped with an APIM?

Yes

GO to W30.

No

REPAIR the circuit. CONNECT all modules. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.

-------------------------------------------------
W30 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE APIM DISCONNECTED

Initial Inspection and Diagnostic Overview|Page 3204 > < Initial Inspection and Diagnostic Overview|Page 3202