ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Water Pump - Vehicles Built Up To: 01-1999 1.3L Endura-E (HCS) > < Heater Core Backflushing

Fiesta 1996 (08.1995-02.2002)

Engine Cooling - Water Pump—Vehicles Built From: 01/1999 1.3L Endura-E (HCS) Fiesta 1996 (08/1995-02/2002)
Removal and Installation

Special Tool(s)

Remover/Installer, cooling hose clamp

24-003

Removal

  1. Disconnect the battery ground cable.
  1. Drain the cooling system (refer to procedure contained in this section).

  1. Loosen the three water pump pulley bolts.
  1. De-tension and remove the drive belt. For additional information, refer to Section  303-05 Accessory Drive.

  1. Remove the water pump pulley.

  1. Disconnect the coolant hose.

  1. Remove the water pump (three bolts).
    • Discard the water pump gasket.

Installation
  1. NOTE:
    NOTE:Make sure the mating faces of the cylinder block and water pump are clean.
    Refit the water pump (three bolts).
    • Install a new water pump gasket.
  1. Refit the coolant hose.
  1. Loosely refit the water pump pulley.
  1. Refit the drive belt. For additional information, refer to Section  303-05 Accessory Drive.

  1. Tighten the three water pump pulley bolts.
  1. Refill the cooling system and check for leaks (refer to procedure contained in this section).

Water Pump - Vehicles Built Up To: 01-1999 1.3L Endura-E (HCS) > < Heater Core Backflushing