Ford Workshop Service and Repair Manuals > Fiesta 1996 (08.1995-02.2002) > Mechanical Repairs | 3 Powertrain | 308 Manual Transmission-Transaxle, Clutch and Transfer Case | 308-02 Clutch Controls | Description and Operation | Diagnosis and Testing | Removal and Installation

Clutch Controls - Clutch Master Cylinder

Fiesta 1996 (08/1995-02/2002)

Removal and Installation

Removal

Vehicles built up to 08/1999

WARNING:Brake fluid contains polyglycol ether and polyglycol. Prevent eye contact. Wash your hands thoroughly after working with brake fluid. If brake fluid gets into the eyes, wash the eyes with cold running water for 15 minutes. If the irritation persists, call a doctor. If brake fluid is swallowed, drink water and induce vomiting. Call a doctor immediately. Failure to observe these instructions can lead to personal injury.

CAUTION:If brake fluid contacts the paintwork, rinse the affected areas immediately with cold water.

Detach the pipes in the engine compartment from the clutch master cylinder.
1. Pull the clip and pull off the feed line.
1. Pull off the clip and disconnect the high-pressure line.

Installation

Install the clutch master cylinder.
1. Lift up the brake pedal and screw in the bolts.
1. Lift up the clutch pedal and screw in the bolts.
1. Fit the bolt and insert the clip.
1. Hook the clutch pedal return spring in place.

NOTE:Correct seating of the clip.

Install the pipes in the engine compartment on the clutch master cylinder.
1. Push on the feed line and insert the clip.
1. Connect the high-pressure line and insert the clip.

Bleed the hydraulic clutch system.
- For additional information, refer to Section 308-00 Manual Transmission/Transaxle and Clutch - General Information.

Ford Workshop Service and Repair Manuals