Ford Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
In-vehicle Repair|Removal >
< Halfshaft Seal RH
Fiesta 1996 (08.1995-02.2002)
Mechanical Repairs
3 Powertrain
308 Manual Transmission-Transaxle, Clutch and Transfer Case
308-03 Manual Transmission-Transaxle
Description and Operation / Diagnosis and Testing
General Procedures
In-vehicle Repair
Speedometer Driven Gear
Manual Transmission/Transaxle - Speedometer Driven Gear
Fiesta 1996 (08/1995-02/2002)
In-vehicle Repair
Materials
Name
Specification
Cable ties
Removal
Standard preparatory measures
Make a note of the radio keycode.
Make a note of the pre-programmed radio stations.
CAUTION:
Disconnect the battery negative lead.
Remove the battery.
Separate the connector for the vehicle speed sensor (VSS).
Separate
cable ties
as necessary.
Raise the vehicle. For additional information, refer to Section
100-02 Jacking and Lifting
.
Detach the speedometer cable and unscrew and remove the VSS.
Remove the speedometer drive pinion.
Remove the roll pin.
Pull out the speedometer drive pinion.
Installation
Install the speedometer drive pinion.
Put in the drive pinion.
Drive the roll pin in.
Screw on the VSS and install the speedometer drive cable.
Lower the vehicle.
Join the VSS connector.
Secure with
cable ties
as necessary.
Standard finishing operations.
Install the battery.
Connect the battery negative lead.
Enter the radio keycode.
Reprogram the pre-set radio stations.
Reset the clock.
Road test the vehicle to collect data for the PCM.
Mechanical Repairs
3 Powertrain
308 Manual Transmission-Transaxle, Clutch and Transfer Case
308-03 Manual Transmission-Transaxle
Description and Operation / Diagnosis and Testing
General Procedures
In-vehicle Repair
Speedometer Driven Gear
In-vehicle Repair|Removal >
< Halfshaft Seal RH