ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

General Procedures > < Acceleration Control
Acceleration Control - Acceleration Control Fiesta 1996 (08/1995-02/2002)
Diagnosis and Testing

Inspection and Verification

  1. Verify the customer concern.
  1. Visually inspect for obvious signs of mechanical or electrical damage.

Visual Inspection Chart

Mechanical Electrical
Accelerator pedal Fuse(s)
Accelerator cable Relay(s)
Linkage Wiring harness
Electrical connector(s)
Powertrain control module (PCM)
  1. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  1. If the concern is not visually evident, verify the symptom and refer to the Symptom Chart.

Symptom Chart

Symptom Possible Sources Action
Accelerator pedal is hard to depress or has a rough/raspy or sticky feel
*
Damaged accelerator cable.
*
INSTALL a new accelerator cable.
*
Accelerator cable incorrectly installed.
*
CHECK the accelerator cable for correct installation.
*
Worn or damaged throttle body.
*
Accelerator pedal does not return freely
*
Damaged accelerator cable.
*
INSTALL a new accelerator cable.
*
Weak or broken throttle return spring.
*
*
Worn or damaged throttle body.
*
High engine idle speed
*
Damaged accelerator cable.
*
INSTALL a new accelerator cable.
*
Accelerator cable incorrectly installed.
*
CHECK the accelerator cable for correct installation.
*
Worn or damaged throttle body.
*

General Procedures > < Acceleration Control