1
-
Anti-theft alarm and double locking module
4
-
Anti-theft alarm inhibit switch
7
-
Key activated set/reset switch
8
-
Infrared remote control transmitter
The alarm system can be set only by locking either front door with the key or by the remote control transmitter. It cannot be set from the interior door handles or liftgate lock. The anti-theft/double locking control module is triggered by closing input circuit loops, therefore the alarm is unable to activate until all the input circuits are in a closed circuit position. This is achieved only once the doors, hood and liftgate are fully closed.
A liftgate alarm inhibit switch prevents the alarm sounding when opening the liftgate with a key whilst the system is armed.
When the alarm is triggered, the alarm horn emits an intermittent signal for a maximum of thirty seconds (in order to comply with certain legislation) and the hazard flashers will also operate for five minutes. The system remains armed after this and will be triggered again by any subsequent activation.
The alarm can be switched off only by unlocking one of the front door switch the key or remote control.
Anti-Theft and Double Locking Module – Vehicles Built up to 01/1999