ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Liftgate Latch Actuator > < Door Latch Remote Control

Fiesta 1996 (08.1995-02.2002)

Handles, Locks, Latches and Entry Systems - Door Lock Cylinder Fiesta 1996 (08/1995-02/2002)
Disassembly and Assembly

Materials
Name
Specification
Lock barrel grease
WSS-M1C253-A 

Disassembly
  1. NOTE:
    NOTE:Determine the key code of the lock either by examining the key, key cutting kit instructions, the customers service records or by dismantling the lock and examining the numbers stamped on each number. Alternatively, identify the tumblers (by reading the notches on each tumbler edge) and make a note of the key code.
    Read the key code.
    • The key code can be read as follows:
    • 1 notch = 1, 2 notches = 2, 3 notches = 3 and 0 notches =4

Assembly
  1. NOTE:
    NOTE:The first tumbler inserted into the tumbler magazine should be the last number of the key code. This should be followed by the spring washer.
    Arrange the tumblers, spring washer and the spacers to enter the tumbler magazine.
    1. Tumblers.
    1. Spring washer.
    1. Spacers.

  1. Install the tumblers and the spacers so that their grooves are aligned with the cut-out slot in the side of the tumbler magazine.
  1. Pack the tumbler magazine with lock barrel grease.

  1. NOTE:
    NOTE:Cover the roller with lock barrel grease.
    Insert the roller into the cut-out slot in the side of the tumbler magazine.

  1. NOTE:
    NOTE:Make sure the roller locates into the corresponding slot in the lock housing.
    Insert the tumbler magazine into the lock housing.
  1. NOTE:
    NOTE:Keep the lock assembly in its current position.
    Insert the relevant key to make sure that the barrel operates correctly.

  1. Fit the self-locking retainer ensuring that all of the tangs are locked into position.

  1. Fit the alarm actuator.

  1. NOTE:
    NOTE:Cross the lever return spring tangs.
    Install the lever return spring.

  1. NOTE:
    NOTE:An R for right-hand or L for left-hand stamped on to the operating lever will determine which door lock it operates.
    Install the operating lever.

  1. Install the retaining clip.

Liftgate Latch Actuator > < Door Latch Remote Control