Removal and Installation | -
Disconnect the battery ground cable. For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Raise and support the vehicle. For additional information, refer to: Lifting (100-02 Jacking and Lifting, Description and Operation). | 3. Remove the components in the order indicated in the following illustration(s) and table(s). 2 - Starter motor wiring harness support bracket 4. To install, reverse the removal procedure. Removal Details Item 1 : Starter motor electrical connectors | -
Disconnect the ignition switch and battery to starter motor solenoid cables. | Item 3 : Starter motor | -
Discard the starter motor gasket. | Installation Details Item 1 : Starter motor electrical connectors | -
NOTE:Clean the electrical connectors before connecting the cables. Failure to follow this instruction may cause a high resistance between the electrical connectors and the starter motor solenoid. Connect the ignition switch and battery to starter motor solenoid cables. | Item 3 : Starter motor | -
NOTE:Clean the mating surfaces before installing the new starter motor gasket. Install a new starter motor gasket into the transaxle housing prior to installing the starter motor. | |