ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Crankshaft Position (CKP) Sensor - 1.4L Duratorq-TDCi (DV) Diesel > < Electronic Engine Controls

Fiesta 2002.25 (11.2001-)

Electronic Engine Controls - Camshaft Position (CMP) Sensor—1.4L Duratorq-TDCi (DV) Diesel Fiesta 2002.25 (11/2001-)
Removal and Installation

Removal
  1. Disconnect the CMP sensor electrical connector.

  1. Remove the CMP sensor.
    • Discard the CMP sensor.

Installation

NOTE:
NOTE:Install a new CMP sensor.
  1. NOTE:
    NOTE:Only turn the engine in the normal direction of rotation.
    Turn the engine until one of the three webs on the back of the camshaft pulley is visible through the CMP sensor housing (timing belt upper cover shown removed for clarity).

  1. CAUTION:
    CAUTION:The CMP sensor tip must rest on one of the three webs on the back of the camshaft pulley. Incorrect installation may result in the CMP sensor being damaged.
    Install the CMP sensor until the tip of the sensor touches the back of the camshaft pulley (timing belt upper cover shown removed for clarity).

  1. Tighten the CMP sensor retaining bolt.

  1. Connect the CMP sensor electrical connector.

Crankshaft Position (CKP) Sensor - 1.4L Duratorq-TDCi (DV) Diesel > < Electronic Engine Controls