Flex FWD V6-3.5L (2010)
5. Remove 4 screws and the backrest hard back panel.
6. NOTE: The head restraint guides are not interchangeable.
Squeeze the tabs in and remove the 2 head restraint guides.
7. Remove the backrest trim cover.
8. NOTE: Always install a new backrest foam pad and new backrest heater mat together.
Remove the backrest foam pad.
-
If equipped, note heater mat wiring harness routing for installation.
9. To assemble, reverse the disassembly procedure.
Seat Backrest - Second Row, 60 Percent
Seat Backrest - Second Row, 60 Percent
Disassembly
60 Percent Backrest
NOTE: Refer to steps in this procedure for inner safety belt guide and safety belt retractor bolt tightening sequence and torque specification.