Flex FWD V6-3.5L (2010)
7. Roll the backrest cover down and install the 3 first row hog rings.
8. If equipped with a DVD player, install the 2 head restraint guides sleeves. For additional information, refer to Head Restraint Guide Sleeve See:
Head Rest/Service and Repair/Head Restraint Guide Sleeve.
9. Roll the backrest cover all the way down.
10. Route the wire harness and cables out through the sides of the backrest cover.
11. Position the backrest assembly and install the 2 outboard recliner-to-backrest frame bolts finger-tight.
-
Make sure the fold-flat cable, lumbar cable (if equipped) and backrest feed wire harness (if equipped) are routed out through the backrest
cover before installing the bolts.
12. Position the backrest assembly and install the 2 inboard recliner-to-backrest frame bolts finger-tight.
-
Make sure the fold-flat cable and DVD wire harness (if equipped) are routed out through the backrest cover before installing the inboard
recliner.
13. Install the 4 recliner-to-backrest frame bolts.
-
Tighten to 63 Nm (46 lb-ft).
14. Attach the fold-flat cable retainer, cover and DVD player wire harness pin-type retainers (if equipped) to the inboard recliner.
